EPSON AcuLaser C9200N Revision D
PRODUCT DESCRIPTION List of Printer Messages 28
Confidential
1.2.2 Warning Message and Troubleshooting
Table 1-8. Warning Message and Troubleshooting
Message Explanation Remedy
Reserve Job Canceled
An attempt has been made to
register a new Re-Print Job, Verify
Job, Stored Job or Confidential Job
though the number of registrations
has reached the maximum.
Delete or print the registered
Re-Print Jobs, Verify Jobs,
Stored Jobs or Confidential
Jobs.
When the user attempted to register
a Re-Print Job or Verify Job, there
was already a Stored Job registered
by same user name or job name.
When there is another Stored
Job with the same user name or
job name, either change the job
name and register it or delete
the Stored Job.
Insufficient capacity of RAM disk.
Or, RAM Disk is set to Off.
Set RAM Disk to Normal or
Maximum if RAM Disk is set
to Off. Increase the RAM Disk
capacity or add more RAM if
RAM Disk is already set to
Normal or Maximum.
Insufficient capacity of
CompactFlash. Or, a
CompactFlash is not installed.
Install a CompactFlash if a
CompactFlash is not installed.
CompactFlash Full
The CompactFlash memory is full
and collated print jobs, form data,
reserve jobs etc. cannot be saved.
Delete unnecessary form data
and Reserve Jobs (Re-Print,
Verify, Stored, and
Confidential).
Form Data Canceled
The user attempted registration
after reaching the maximum
number.
Delete registered forms. Or,
replace the USB memory.
The USB memory is not installed,
or was removed while registering.
Or, the capacity of the USB
memory is insufficient.
Check if the USB memory is
installed. Or, replace with
another USB memory with a
larger capacity.
A CompactFlash is not installed. Install a CompactFlash.
PS3CompactFlash Full
When downloading PS3 fonts, the
CompactFlash memory is full and
the fonts cannot be saved.
Delete previously downloaded
fonts to empty the
CompactFlash memory.
Can't Print
Data was disregarded and not
printed due to a problem in the
data. The following are conditions
of this warning.
Bandwidth of the received data
does not match the value
determined by the paper size.
The received data contains
undefined intermediate codes or
compression format.
Checksums attached to the
intermediate code data using
ESC/Page and ESC/Page-Color
do not match checksums of the
actual data.
Data cannot be read from the
USB memory where print data
is stored.
This error occurs when a
printer driver for a different
printer is used. Check the
printer and reinstall it if it is an
incorrect driver. When printing
from a USB memory, check
and reinsert the USB memory.
Check Paper Size
The paper size for the loaded paper
and specified paper do not match.
Set the paper of the specified
size.
Image Optimum
Printing with PS
This warning occurs when
memory is insufficient, and the
resolution is reduced.
Printing with the ESC/Page-
Color driver or EPSON PCL
driver
This warning occurs when data
is compressed with a higher
level of compression.
Printing with PS
Add memory.
ESC/Page-Color driver or
EPSON PCL driver
Set the priority of the driver
data compression method
to quality.
Not Supported USB
Device xxx
The USB device (other than a
memory device) or a USB memory
with a hub currently connected to
the USB port is not supported. A
file check is performed whenever a
new device is found on the USB
port, and this error occurs at the
point.
Disconnect the USB memory
from the USB port, or specify
Clear Warning to clear the
warning.
Table 1-8. Warning Message and Troubleshooting
Message Explanation Remedy
To Next Page
Loading...
