Epson Aculaser C9200N - Special Menu

EPSON AcuLaser C9200N Revision D
APPENDIX Control Panel Special Operations 349
Confidential
7.4.2 Special Menu
The following special adjustment menu is provided.
The underlined values are default values.
SUPPORT MENU
PRINTER ADJUSTMENT FUNCTION
Setting item Settings Explanation
Support
StatusSheet
Execute Prints the Support Status Sheet.
LCD Backlight
Auto On Off Sets the operation of LCD Backlight.
Format
CompactFlash
Execute Formats the CompactFlash.
Format PS3
CompactFlash
Execute
Delete All
CompactFlash
Data
Execute Deletes all CompactFlash data.
Setting item Settings Explanation
Highland 0 ~ 1 White spots may appear when using the printer in
a highland area. In such case, this setting is set to
“1”. Therefore, developing bias is changed to
prevent some wrong.
Feed Offset
-3.5 ~ 0.0 ~ 3.5 Sets Physical offset for the front of a page in the
paper feeding direction.
Scan Offset
-3.5 ~ 0.0 ~ 3.5 Sets Physical offset for the front of a page in the
scanning direction.
Feed Offset2
-3.5 ~ 0.0 ~ 3.5 Sets Physical offset for the back of a page in the
paper feeding direction.
Scan Offset2
-3.5 ~ 0.0 ~ 3.5 Sets Physical offset for the back of a page in the
scanning direction.
TR Normal -5 ~ 5 Sets the secondary transfer bias for each paper
type. Setting items with "Back" are for the back of
papers.
TR Thick
-5 ~ 5
TR ExtraThk -5 ~ 5
TR SuperThk -5 ~ 5
TR Envelope -5 ~ 5
TR Tmsprnc -5 ~ 5
TR Card -5 ~ 5
TR NormalBack -5 ~ 5
TR ThickBack -5 ~ 5
TR ExtraThkBack -5 ~ 5
TR SuperThkBack -5 ~ 5
TR Card Back -5 ~ 5
Max Density K -10 ~ 10 Sets the max density for each color. This setting is
executed to heighten a color. This setting is
available after executing calibration.
Max Density C
-10 ~ 10
Max Density M -10 ~ 10
Max Density Y -10 ~ 10
Blur Margin K -5 ~ 5 Sets the blur margin for each color.
Blur Margin C
-5 ~ 5
Blur Margin M -5 ~ 5
Blur Margin Y -5 ~ 5
Definition Noise 0 ~ 3 ~ 7 This setting is not used for the service since it is a
menu for development.
Gradation Noise
0 ~ 3 ~ 7 This setting is not used for the service since it is a
menu for development.
Calibration
Execute Executes the calibration of engine.
Color DiagnosisSht
Execute Prints a sheet for the check of image quality.
Setting item Settings Explanation