Epson Aculaser C9200N - Other Errors

EPSON AcuLaser C9200N Revision D
Troubleshooting Service Call Error 131
Confidential
3.3.4 Other Errors
Details for troubleshooting on error message “Photocon Trouble uuuu”.
 Cause
 Adhesion toner on transfer belt is outside a proper range while image stabilizing control
 Abnormal access between Photoconductor unit IC chip and Printer
 Error-causing Part
 High voltage contact point between Photoconductor unit and High Voltage Unit
 Photoconductor unit
 PH unit
 Transfer belt unit
 Waste toner pipe
 Waste toner box
 High voltage unit
 Mechanical Control Board
 Troubleshooting
Table 3-19. Troubleshooting
Step Remedy and Check Point Yes No
1
Check the connection status of cable and connector.
 Photoconductor unit - High voltage unit
 Photoconductor unit - Mechanical Control Board - Controller Board
Correct connection Go to Step2