Epson Aculaser C9200N - Cleaning Procedures

EPSON AcuLaser C9200N Revision D
MAINTENANCE Cleaning 332
Confidential
6.1 Cleaning
Clean the parts listed in the table below according to the printer condition.
MAIN UNIT
 Printer exterior surface
Wipe the surface clean with a cloth wrung out of water.
Figure 6-1. Cleaning the Printer Surface
Table 6-1. Cleaning
Unit Cleaning point Cleaning Requirements
Main unit Printer exterior surface When the exterior is stained (dirty or
dusty).
PH window When white streaks (missing areas)
appear on the printing result.
Transfer belt When image quality problems such
as bands, unevenness or smudges
occur.
Registration roller When the Registration roller is dirty
and it affects the image.
Area around the waste toner
collecting port
When area around the waste toner
collector is stained with toner.
Feed roller (Standard cassette (C1)) When malfunctions in paper feeding
such as multiple-sheet feed, non-
feed, or skew occur frequently.
Separation roller (Standard cassette
(C1))
Feed roller (MP tray)
Separation roller (MP tray)
Optional
cassette unit
Feed roller
Separation roller
Transport roller
Duplex unit Transport roller
Ventilation Section
When the Ventilation Section is dirty.
Make sure to turn the power switch OFF and unplug the power
code before cleaning to avoid electric shock, burn or any other
injuries.
 Do not use alcohol, thinner, or any other solvents. When using
these ones, follow the instructions of the procedures.
 Be extremely careful not to make the internal parts of the
printer get wet.
 A hard brush or cloth can scratch the product. Do not use them
to wipe the product.