Epson Aculaser C9200N - 4-Color> Colored Spots; C F; 4-Color; Poor Fusing Performance, Offset

EPSON AcuLaser C9200N Revision D
Troubleshooting Image quality problem 153
Confidential
<4-COLOR>
COLORED SPOTS
A. Typical Faulty Images
B. Troubleshooting Procedure
<4-COLOR>
POOR FUSING PERFORMANCE, OFFSET
A. Typical Faulty Images
B. Troubleshooting Procedure
Step Section Check Item Result Action
1 Photoconductor
Unit
The surface of the PC Drum is
scratched.
YES Change Photoconductor Unit.
(p.162)
2 Transfer Belt
Unit
Fingerprints, oil, or other
foreign matter is evident on
the Transfer Belt.
YES Clean with specified solvent.
(Refer to Chapter 6 "
MAINTENANCE (p. 331)")
3 Transfer Belt is dirty or
scratched.
YES Clean dirty belt with a soft
cloth. Change Transfer Belt
Unit that has damages.
4 2nd Transfer
Roller
2nd Transfer Roller is dirty or
scratched.
YES Change 2nd Transfer Roller.
(p.169)
5 Paper path There is foreign matter on
paper path.
YES Remove foreign matter.
6 Fusing Unit Fusing Belt is dirty or
scratched.
YES Change Fusing Unit. (p.162)
7 The problem has been
eliminated through the checks
of steps up to 6.
NO Change Transfer Belt Unit.
(p.162)
AAAA
4036fs4052c0
Step Section Check Item Result Action
1 Paper Paper type does not match. YES Change the setting.
2 The problem has been
eliminated through the check
of step up to 1.
NO Change Fusing Unit. (p.162)
C F
C FC F
4036fs4060c0
C FC F
4036fs4059c0
Poor fusing
performance
Offset