Epson Aculaser C9200N - Page 185

EPSON AcuLaser C9200N Revision D
DISASSEMBLY AND ASSEMBLY Main Unit Disassembly/Reassembly 185
Confidential
 Insert the Transfer Belt Unit into the Main Unit completely and make sure the
Drive Gear of the Transfer Belt Unit matches with that of the Main Unit. And then,
secure them with Screws. If they are secured even though both Drive Gears have
not been matched, the Main Unit may be damaged when closing the cover.
Matched Not Matched
PH Interface Board (PWB-D)
1. Pull out the Paper Cassette 1.
2. Remove two Screws [1], and remove the Front Right Cover [2].
C10
[1]
[2]
4038F2C097DA