Epson Aculaser C9200N - Page 213

EPSON AcuLaser C9200N Revision D
DISASSEMBLY AND ASSEMBLY Main Unit Disassembly/Reassembly 213
Confidential
2. Open the right door.
3. Disengage the boss of the guide [1] to free the guide [1].
4. Remove one Screw [2].
5. Remove four Screws [3] and remove the Multi Bypass Unit [4].
[2]
[1]
Boss
[3]
[3]
[4]
When assembling the Guide again after the Guide has been removed for some reason,
insert the Hinge to the position as shown in the figure above. Additionally, when
changing the position of the Hinge, once pull out the Hinge and install it again. If the
position is changed with the Hinge installed, D-shaped slot may be damaged under
load.