Epson Aculaser C9200N - Page 26

EPSON AcuLaser C9200N Revision D
PRODUCT DESCRIPTION List of Printer Messages 26
Confidential
Replace Photocon uuuu
 Printing has stopped because
the photoconductor unit of
the specified color has
reached its lifetime.
 Cannot be cleared by the
Start/Stop switch.
 Error LED flashing
 Replace with a new
photoconductor unit of
the specified color.
 Press the Start/Stop
switch to clear the error
and continue printing.
 Error LED On
Replace with a new
photoconductor unit of the
specified color.
Replace Waste Toner
Box
 The waste toner box is at the
end of its product lifetime.
 Cannot be cleared by the
Start/Stop switch.
Replace with a new waste toner
box.
Replace Fuser
 Printing has stopped because
the fuser unit has reached its
lifetime.
 Can be cleared by the Start/
Stop switch.
 Error LED flashing
 Replace with a new fuser
unit.
 Press the Start/Stop
switch to clear the error
and continue printing.
 Error LED On
Replace with a new fuser
unit.
Replace Transfer Unit
 Printing has stopped because
the transfer unit has reached
its lifetime.
 Can be cleared by the Start/
Stop switch.
 Replace with a new transfer
unit.
 Press the Start/Stop switch to
clear the error and continue
printing.
Replace Maintenance
Unit
 Printing has stopped because
the maintenance unit has
reached its lifetime.
 Can be cleared by the Start/
Stop switch.
 Replace with a new
maintenance unit. After
replacement, perform Reset
Maint Counter on the panel.
 Press the Start/Stop switch
to clear the error and
continue printing.
Table 1-7. Error Message and Troubleshooting
Message Explanation Remedy
Replace Feed Roller xxx
 Printing has stopped because
the paper feed roller has
reached its lifetime.
 Can be cleared by the Start/
Stop switch.
 Contact Service and replace
the paper feed roller. After
replacement, perform Reset
xxx Counter on the panel.
 Press the Start/Stop switch to
clear the error and continue
printing.
Set Release Lever to ppp
Position
Displayed when there is an
envelope print request after
printing plain paper, or a plain
paper print request after printing
envelopes, prompting the user to
set the release lever to the
correct position.
Open cover A, set the release
lever to the position shown in
the message, and close cover A.
wwww Open A cover is open.
The error is cleared by closing
the cover specified. Refer to
Figure 1-8.
Table 1-7. Error Message and Troubleshooting
Message Explanation Remedy