Epson AcuLaser CX17 Series - Page 253

10BASE-T Full
Uses 10base-T full-duplex.
100BASE-TX Half
Uses 100base-TX half-duplex.
100BASE-TX Full
Uses 100base-TX full-duplex.
Note:
This item is displayed only when the printer is connected with a wired network.
Status (Epson AcuLaser CX17WF Only)
Purpose:
To display the information on the wireless signal strength. No changes can be made on the operator
panel to improve the status of the wireless connection.
Values:
Good
Indicates good signal strength.
Acceptable
Indicates marginal signal strength.
Low
Indicates insufficient signal strength.
No Reception
Indicates that no signal is received.
Note:
This item is displayed only when the printer is connected with a wireless network.
Wireless Setup (Epson AcuLaser CX17WF Only)
Purpose:
To configure the wireless network interface.
Epson AcuLaser CX17 Series User’s Guide
Using the Operator Panel Menus and Keypad 253