Cleaning the Printer
To keep your printer operating at its best, you should clean it
thoroughly several times a year. Follow these steps:
1.
Make sure the printer is turned off. Then remove any paper as
well as the paper guide and tractor unit. Also remove the
optional pull tractor
and cut-sheet feeders, if installed.
2. Use a soft brush to carefully brush away all dust and dirt from
the outer case.
3. If the outer case or paper guide is still dirty, clean it with a soft,
clean cloth dampened with mild detergent dissolved in water.
Keep the printer cover in place and close the paper-guide
cover to prevent water from getting inside the printer.
Warning:
Be careful
not to
get water
on the printer mechanism or electronic
components.
Caution:
Never use alcohols or thinners to clean the printer; these
chemicals can damage the components and the case.
Do not use a hard or abrasive brush.
Do not spray the inside of the printer with lubricants;
unsuitable oils can damage the mechanism. Contact your
dealer if lubrication is needed.
5-2
Maintenance and Transportation
To Next Page
Loading...
