Options
See this section if you have problems with optional equipment.
The paper does not feed properly with the cut-sheet
feeder
The paper does not feed.
The cut-sheet feeder may be incorrectly installed. Reinstall it as
described in Chapter 4.
You may have loaded too many sheets in the cut-sheet feeder’s
bin. Make sure the bin contains no more than 150 sheets.
Paper may be jammed near the print head. Look for a paper
jam and remove it.
Make sure the edge guide positions on the paper guide of the
cut sheet feeder are correct. Position the edge guides at the
diamond-shaped guide marks.
There may be only one sheet left in the bin. Add more paper.
Two or more sheets feed at one time.
You may have loaded too many sheets in the cut-sheet
feeder’s bin. Make sure the bin contains no more than 150
sheets.
You may have forgotten to fan the stack of paper before
loading it into the bin, Remove the paper, fan it, and re-load it.
6-10 Troubleshooting
To Next Page
Loading...
Need help?
General
