This chapter describes how to use optional equipment with your
printer, including cut-sheet feeders, a pull tractor, a roll paper
holder, and interface cards.
Cut-Sheet Feeders
Two cut-sheet feeders are available for use with your printer.
Printer model
High capacity (Bin 1)
Second bin (Bin 2)
Fx-2170 C80673*
C80674*
The asterisk (*) is a substitute for the last digit, which varies by country,
Contact your local EPSON dealer for the part number in your country.
By connecting both cut-sheet feeders, you can operate them as a
double bin cut-sheet feeder. This allows you to load two different
types of paper. See “Assembling the double bin cut-sheet feeder”
later in this chapter.
Before you install your cut-sheet feeder, assemble it by following
the instructions in the manual that comes with it.
Note:
The second bin cut-sheet feeder can only be used in combination with the
high capacity cut-sheet feeder.
Installing the high capacity cut-sheet feeder
1.
Make sure the printer is turned off.
2.
Remove the paper guide and the printer cover.
4-2
Using Printer Options
To Next Page
Loading...
