7.
Fit the paper to the pull tractor’s sprocket.
8.
Move the paper release lever to the pull tractor position and use
micro adjust, described in Chapter 3, to remove any slack in
the paper.
9. Move the paper release lever back to the push tractor position.
10.
Attach the paper guide and printer cover. Raise the paper path
guide and rest it against the paper guide.
Note:
When you are using more than one continuous paper source, guide the
paper over the paper guide and
feed
it out the back of the printer, as it
prints.
Caution:
Do not use the knob on the right side of the printer except to clear
paper jams when the printer is off. Otherwise, you may damage
the printer
or cause
it to
lose
the
top-of-form position.
Roll Paper Holder
The optional roll paper holder (#8310) allows you to use your
printer with 8.5-inch roll paper like that used with telex machines.
Before you use roll paper, set the default setting of roll paper to
on. See “Changing the Default Settings” in Chapter 3 for details.
To use the roll paper holder, follow the steps below.
Note:
This option is not available in all countries.
1.
Turn off the printer and make sure the paper release lever is at
the single-sheet position.
Using Printer Options
4-9
To Next Page
Loading...
Need help?
General
