Labels
When selecting labels for printing, always choose the type
mounted on a continuous backing sheet with sprocket holes for
use with a tractor. Do not try to print labels as single sheets
because the shiny backing sheet does not feed properly.
Load labels from either the front or bottom (not rear) paper slots
with the tractor in the pull tractor position. You load them the
same way that you load continuous paper, except you set the
paper thickness lever to position 2. See “Using Continuous Paper”
earlier in this chapter for details.
Caution:
Never
feed
labels
backward
with the
Load/Eject
or
Tear
Off/Bin
buttons. Labels can easily peel off the backing and
jam the printer.
Since labels are especially sensitive to temperature
and
humidity, use
them
only under normal operating
conditions.
Do not leave labels loaded in the printer between jobs; they
curl around the platen and may jam when you resume
printing.
To remove labels from the paper path after you finish
printing, first tear off the labels at a point before the paper
slot.
Then use
the
LF/FF
button to advance
the
remaining
labels out of the printer.
2-28
Paper Handling
To Next Page
Loading...
Need help?
General
