Micro Adjust
The micro adjust feature allows you to move paper forward or
backward in l/216-inch increments. You can use this feature to
adjust the loading and tear-off positions.
This section explains how to use micro adjust. See the next section
for information on adjusting the tear-off position.
The loading position is the position of the paper after it has been
automatically loaded by the printer. If your printing appears too
high or low on the page, change the loading position with the
micro adjust feature as follows:
1.
Make sure the printer is turned on. If necessary, lift the printer
cover up so you can see the paper position.
2. Load either continuous or single-sheet paper. (Load continuous
paper by pressing the
Load/Eject
button.)
3. Hold down the
Pause
button for three seconds. The Pause
light starts flashing.
Using the
Printer
3-13
To Next Page
Loading...
Need help?
General
