4.
Press the
Load/Eject
button to move the loading position
down on the page,
or
press the
LF/FF
button to move the
loading position up on the page.
For continuous paper, mark a point 6.5 mm above the perforation
and position the paper as shown. This gives you an 8.5 mm
margin.
Note:
The printer has a minimum and maximum loading position. If
you try to advance the loading position beyond these limits,
the
printer beeps and the paper stops moving.
When the paper reaches
the factory-set
loading position, the
printer beeps and paperfeeding pauses briefly. Use
the factory
setting as a reference
point
when adjusting the loading position.
3-14
using the Printer
To Next Page
Loading...
