On pages 1-18 through l-20, replace the original information
with the new information below.
DOS printer utilities
Your printer driver disk includes the EPSON Remote! and
EPSON Calibration utilities. You can use EPSON Remote! to
change the printer’s default settings from your computer
instead of the control panel. EPSON Calibration is used to
properly align your printout.
Installing EPSON printer utilities
To install the utilities, follow these steps:
1.
2.
3.
4.
Insert the floppy disk containing the printer utilities into
your computer’s disk drive.
From the DOS prompt, type
A: SETUP
(or
B: SETUP); then
press
Enter.
In the screen that appears, select your printer’s name in the
Printer Model window and press
Enter. C: EPUTIL
appears
as the default directory.
Press
Enter.
All the necessary files are copied to the EPUTIL
directory on drive C.
Using EPSON printer utilities
To use your EPSON utilities, follow these steps:
1.
From the DOS prompt, change the current directory to the C
drive.
2.
To use the EPSON Remote!
utility,
type
PRNSET,
and press
Enter,
or to use the EPSON Calibration utility, type
CALIBRAT,
and press
Enter.
3. Follow the instructions on the screen to use either utility.
6
To Next Page
Loading...
Need help?
General
