4.
You can also try adjusting the form length setting. For a
standard 8l/2 x l1-inch page, try setting the form length at
10 inches.
5. Some programs also let you indicate whether you are using
single sheets or continuous paper. Make sure you choose
single sheets.
Page length does not match the length of the paper.
Check the page length set by your software and adjust it if
necessary.
If you are using continuous paper, change the page length
using the Default Setting mode. See “Changing the Default
Settings" in Chapter 3.
Regular gaps occur in the printout.
Skip-over-perforation may be on. Set skip-over-perforation to
Off in the Default Setting mode. See “Changing the Default
Settings” in Chapter 3.
Paper Handing
See this section if you have problems with paper.
Single sheets do not feed properly
Paper does not feed.
Continuous paper may be left in the printer. Remove the
continuous paper. Set the paper release lever to the single-
sheet position and insert a new sheet.
Troubleshooting 6-7
To Next Page
Loading...
Need help?
General
