2.
Position the roll paper holder beneath the printer as shown
below. Fit the two holes in the base onto the two positioning
pegs on the bottom of the printer.
Caution:
Be careful to
avoid
dropping the roll paper
holder when lifting the
printer. Only the printer’s weight holds it in place.
3.
Cut the leading edge of the roll paper straight across. Slide the
roll paper holder shaft through the center of the paper roll.
4.
Set the shaft and paper roll onto the roll paper holder so that
paper feeds from the bottom of the roll.
4-10
using Printer Options
To Next Page
Loading...
Need help?
General
