On page 1-15, add the information below.
Installing the driver for Windows 95 users
Follow these steps to install the printer driver using the
Windows 95 plug-and play capabilities:
Note:
To install the
driver
using the Windows 95 plug-and play
capabilities, your computer’s parallel port must be an IEEE-2284
(ECP or EPP compatible) bidirectional parallel port. See
your
computer documentation for
more
information.
1.
Make sure plain paper is loaded in the printer and the
printer is connected to the computer’s parallel port. (The
paper is used to perform a test print in step 11.)
2.
Turn off your printer and computer, if necessary.
3.
Turn on the printer first; then turn on the computer. Your
computer begins loading Windows 95.
4.
If you defined a password, enter it at the prompt. You see
the New Hardware Found screen.
Note:
If you do not see the New Hardware Found screen, please follow
the procedure under “Installing the driver while running
Windows 95,” the next section.
5. Make sure your printer model name is displayed on the
screen.
Then
click the
Driver from disk provided by
hardware manufacturer
button. Do not select any of the
other buttons.
Note:
The next time you turn
on
your computer after installing the
driver, Windows 95 may display the New Hardware Found
screen again. In this case, click the
Do not install a driver
radio button; then click
OK.
This screen does not appear again.
2
To Next Page
Loading...
Need help?
General
