24 Setting Up the Projector
Follow these steps to turn on the projector:
1. Remove the lens cover.
2. Plug one end of the power cord into the projector, and the other
end into an electrical outlet.
The Ppower light turns orange.
note
You can set the projector to
automatically turn off the
lamp and enter “sleep mode”
when it has not received any
signals for 1 to 30 minutes
(see page 67 to enable,
disable, or adjust this
setting). This conserves
electricity, cools the
projector, and extends the
life of the lamp. If you want
to start projecting again,
press the
P power button. If
you are done using the
projector, unplug the power
cord.
Power light
To Next Page
Loading...
Need help?
General