44 Using the Projector on a Network
Connecting to a Wired Network
With an Ethernet cable, you can connect the projector to your
network and configure it with an IP address.
1. Connect the projector to your network using a commercially
available 100BaseTX or 10BaseT network cable. Connect the
cable to the
LAN port on the projector as shown. To ensure
proper data transmission, use a shielded, Category-5 cable or
better.
2. Connect the other end to your Ethernet hub or router.
3. Turn on the projector.
4. Press the
Menu button, select the Network menu, then press
Enter.
To Next Page
Loading...
