16 Setting Up the Projector
Ideally, you should place the projector directly in front of the center of
the screen, facing it toward the screen squarely. The base of the lens
should be about level with the bottom of the screen.
If you place the projector below screen level, you can use the vertical
lens shift dial to raise the lens (see page 29). You can also tilt the
projector up by extending the front adjustable foot. Tilting the
projector causes the image to become “keystone” shaped, but you can
correct the distortion (see page 30).
For instructions on installing the projector in a permanent location,
such as a theater or conference room, see page 101.
Connecting to a Computer
You can connect the projector to any computer that has a standard
video output (monitor) port, including desktop models, PC and
Macintosh computers, and hand-held devices.
If you have the optional wireless mouse receiver, you can use your
remote control as a wireless mouse when projecting from a computer
(page 39).
note
After positioning the
projector, you may want to
connect a Kensington
MicroSaver
®
anti-theft
device to the lock port on the
projector. You can purchase
this from Epson; see page 9.
Screen
Projector
note
To connect a Macintosh
that includes only a Mini
DisplayPort or Mini-DVI
port for video output, you
need to obtain an adapter
that allows you to connect to
the projector's VGA video
port. Contact Apple for
compatible adapter options.
To Next Page
Loading...
Need help?
General