Maintaining the Projector 81
7. Once the lamp is fully inserted, tighten its screws.
8. Replace the lamp cover, then tighten its screws.
9. Reset the lamp timer as described in the next section.
Resetting the Lamp Timer
After you replace the lamp, you need to reset the lamp timer using the
projector’s menu.
1. Press the
Menu button on the remote control or on the
projector’s control panel. You see the main menu.
2. Use the pointer button on the remote control (or the arrow
buttons on the projector) to highlight
Reset, then press Enter.
You see this screen:
3. Select
Reset Lamp Hours and press Enter.
4. When you see the prompt, select
Yes and press Enter.
To Next Page
Loading...
Need help?
General