Maintenance 9. Troubleshooting
180 RC700 / RC700-A Rev.23
No. Message Remedy Note 1 Note 2
1158
File failure.
Failed to write the settings file.
Restore the controller configuration.
1160
MCD failure.
Failed to open the MCD file.
Restore the controller configuration.
1161
MCD failure.
Failed to read the MCD file.
Restore the controller configuration.
1163
MCD failure.
Failed to save the MCD file.
Restore the controller configuration.
1165
MPD failure.
Failed to open the MPD file.
-
1166
MPD failure.
Failed to read the MPD file.
-
1168
MPD failure.
Failed to save the MPD file.
-
1170
MPL failure.
Failed to open the MPL file.
1. Reboot the controller.
2. Reinstall the firmware.
1181
PRM failure.
Failed to replace the PRM file.
1. Reboot the controller.
2. Reconfigure the robot.
1185
Failed to open the backup
-
1186
File failure.
Failed to read the backup
-
1187
File failure.
Failed to write the backup
-
1188
Failed to save the backup
-
1189
The backup data was created by
an old version.
Cannot restore the controller
configuration in the specified
procedure for using old backup data.
1190
The backup data was created by a
-
1191
There is no project in the backup
-
1192
Cannot execute with invalid robot
number.
Check that the Backup data is same
as current robot number.
1193
Cannot execute with invalid robot
information.
Check that the Backup data is same
as current robot number.
1194
Cannot execute with invalid drive
-
1195
File failure. Failed to map the
Reboot the controller. - -
1196
File failure. Failed to open the
health history file.
Reboot the controller. - -
1197
File failure. Failed to write the
health history file.
Reboot the controller. - -
1200
Compile failure.
Check the compile message.
This error occurs during compilation
from TP. Correct where the error
1201
Link failure.
Check the link message.
This error occurs during compilation
from TP. Correct where the error
To Next Page
Loading...
Need help?
General
