SC-F9200 Series Revision C
ADJUSTMENT Overview 267
SE Group Confidential (Related Staff Only)
Ink supply
related parts/
units
Duct CR
Before
replacement
1 Turn the power on in Serviceman mode. ---
√
---
2 Reset the duct CR counter.
√√
--- p. 293
3 Turn the power off. ---
√
---
4 Turn the power on in Serviceman mode. ---
√√
5 Tube inner pressure reduction
√√√
p.308
6
Activate the ink cartridges for service.
√√√
p. 329
Replacement
7 Auto CR unlock & move CR to full column side
√ √ √
8 Replacement ---
√ √
p. 140
After
replacement
9 Install the ink cartridges for service. ---
√√
p. 207
10 Turn the power on in normal mode. ---
√√
11 Cleaning (CL3 twice + CL1 once)
√√√
p.313
12 Nozzle Check
√
PGPP
√√
p.311
13 Activate the ink tanks.
√√√
p. 329
14 Turn the power off. ---
√√
15 Remove the ink cartridges for service. ---
√√
p. 207
16 Install the ink tanks. ---
√√
p. 207
17 Turn the power on in normal mode. ---
√√
18 Make sure the error never recurs. ---
√√
Paper feed
related parts/
units
PF Motor
Replacement 1 Replacement ---
√ √
p. 213
After
replacement
2 Turn the power on in Serviceman mode. ---
√√
3 Reset the motor counter.
√√
--- p. 293
4 PF Belt Tension check
√
Tensimeter U-507
√√
p. 338
5 PF Motor Measurement & Automatic Adjustment
√√√
p. 356
6 Manual Adjustment for Media Feeding
√
PGPP
√√
p. 341
PF Scale
Replacement 1 Replacement ---
√ √
p. 216
After
replacement
2 Turn the power on in Serviceman mode. ---
√√
3 PC Scale Check
√√√
p. 340
PF Belt
After
replacement
1 PF Belt Tension check
√
Tensimeter U-507
√√
p. 338
PE Sensor
After
replacement
1 Rear AD Adjustment --- Standard Sheet
√√
p. 358
Table 4-1. Adjustment items and the order by repaired part
Class
Replaced or Repaired
(Reattached) Part/Unit
Required Operations
Service
Program
Jig Media Replaced Reattached Page
To Next Page
Loading...
