Epson Stylus CX4300 - 4.2 Disassembly Procedures

EPSON Stylus CX4300/CX4400/CX5500/CX5600/DX4400/DX4450 Revision A
DISASSEMBLY/ASSEMBLY Disassembly Procedures 64
4.2 Disassembly Procedures
This section explains the procedures for disassembling the product.
Unless otherwise stated, reassembly should be carried out in the reverse order of the disassembly procedure.
For detailed engagement relations among main components, refer to the exploded diagrams in the Appendix.
Figure 4-2. Disassembling Flowchart
“4.3.3 Document Cover/
ASF Cover/Support
Arm
(p66)”
“4.5.1 Main Board
(p73)”
“4.6.10 LD
Roller/ASF Unit
(p90)”
“4.6.1 Printhead
(p75)”
“4.6.3 CR Scale
(p79)”
“4.6.4 CR Motor
(p80)”
“4.6.9 Main Frame
(p87)”
“Ink System
(Cap Assy)
(p83)”
“4.6.7 Power
Supply Board
(p85)”
“4.6.8 EJ Frame
Assy/EJ Roller
(p86)”
START
“4.6.12 PF Roller
(p93)”
“4.6.13 PF Motor
(p94)”
“4.6.11 Waste
Ink Pads (p92)”
“Ink System
(Pump Assy)
(p83)”
“4.6.6 Ink System removal (p83)”
The Shortest Way to Remove the Main Frame
The parts/units shown in yellow-shaded box can be removed faster than following the
flowchart. See the section below for the details.
“4.7 The Shortest Way to Remove the Main Frame. (p95)”
“4.6.2 Hopper
(p78)”
“4.3.4 Scanner Unit/
Middle Case/Panel Unit
(p67)”
“4.4 Removing Printer
Mechanism
(p71)”
“4.6.5 CR Unit/
Timing Belt
(p81)”
“4.8.1 Upper Scanner
Housing
(p96)”
“4.8.2 CIS Assy./CIS
Carrier Assy./Scanner
FFC
(p97)”
“4.8.3 Scanner Motor
Unit/Driven Pulley
(p99)”
“4.3.1 Paper Support
Assy.
(p65)”
“4.8 Scanner Section (p96)”
“4.3.2 Stacker Assy.
(p65)”