Epson Stylus CX4300 - Waste Ink Pads

EPSON Stylus CX4300/CX4400/CX5500/CX5600/DX4400/DX4450 Revision A
DISASSEMBLY/ASSEMBLY Disassembling Printer Mechanism 92
4.6.11 Waste Ink Pads
 Part/Unit that should be removed before removing Waste Ink Pads
Document Cover / ASF Cover / Support Arm / Scanner Unit / Middle Case /
Panel Unit / Printer Mechanism / Hopper / Main Board / Main Frame / EJ Frame
Assy. / Print Head / CR Scale / CR Motor / CR Unit / Timing Belt / Ink System /
EJ Frame Assy. / EJ Roller / LD Roller / ASF Unit
 Removal procedure
1. Remove the Waste Ink Pads (x8) from the sections indicated with to
of the Frame Base.
Figure 4-84. Removing Waste Ink Pads
C A U T I O N
When removing the Waste Ink Pads, be careful not to tear the tip
of the induction paper. If it is torn, replace the induction paper.
 When installing the Waste Ink Pads, be sure to insert ribs and
tabs of the Frame Base into the slots and notches of the pads.
 When installing in the section (refer to Figure 4-84), be
sure to match the positioning tabs and press
until it clicks
to secure it in the right position.
 When installing the Waste Ink Pads on the section , be sure
to lay the six parts one on top of another in the order shown in
the figure.
Figure 4-85. Installing Waste Ink Pads (1)
 When installing the Waste Ink Pads on the section (B), make
sure to insert the tips of induction paper between the
and
pads.
Figure 4-86. Installing Waste Ink Pads (2)
A D J U S T M E N T
R E Q U I R E D
After replacing the Waste Ink Pads, perform the following
adjustment (TBD). (Refer to Chapter 5 “ ADJUSTMENT (p100)”)
1. “Waste Ink Pad Counter” (only after replacement)
2. “Ink Charge”
3. “TOP Margin Adjustment”
4. “Head Angular Adjustment”
5. “Bi-D Adjustment”
6. “PF Band Adjustment”
Tips of induction paper