Epson Stylus Pro 9900 - Page 296

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 296
Confidential
 Disassembling procedure for the new type after design change
1. Remove the Control Panel. (p203)
2. Remove the IC Cover R and the IC Shaft Cover R. (p206)
3. Remove the Maintenance Tank R. (p208)
4. Remove the Right Cover. (p209)
5. Remove the three screws that secure the AID Board Cover.
A) Silver, Phillips, Round Washer Head S-tite M3x6: three pieces
6. Remove the AID Board Cover.
Figure 4-149. Removing the AID Board Cover
C H E C K
P O I N T
5. Secure the new AID Board Cover with the three screws.
6. Install the Spindle Cover R.
(p215)
7. Install the Right Cover. (p209)
8. Install the Maintenance Tank R. (p208)
9. Install the IC Cover R and the IC Shaft Cover R. (p206)
10. Install the Control Panel. (p203)
A D J U S T M E N T
R E Q U I R E D
Be sure to refer to Chapter 5 “Adjustment” (see p351) and perform
specified adjustments after replacing or removing the AID Board.
<Adjustment Item>
1. Counter Clear (AID)
2. Cleaning PG Adjustment
3. AID Function Check
AID Board Cover
C A U T I O N
The old AID Board cannot be installed to a new main body. Make
sure to prepare the new AID Board before taking the following
procedure.
AID Board Cover
A
- Top right -