Epson Stylus Pro 9900 - Page 347

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 347
Confidential
4.4.8.18 Carriage Motor
1. Remove the Color Measurement Device. (p325)
2. Remove the Mounter. (p327)
3. Remove the Front Cover. (p331)
4. Remove the three screws that secure the shield plate, and remove the shield plate.
A) Silver, Phillips, Bind machine screw M3x6: three pieces
5. Disconnect the relay connector, and release the cable from the clamp and the cable
retainer.
Figure 4-226. Removing the shield Plate
Figure 4-227. Disconnecting the relay connector
A
Shield Plate
Cable Retainer
Clamps
Relay connector