Epson T-B Series Maintenance Manual

T3-B T6-B Maintenance 15. LED Lamp Unit
126 T-B series Maintenance Manual Rev.1
15. LED Lamp Unit
WARNING
■
Do not connect or disconnect the connectors while the power to the robot system
is turned ON. Connecting or disconnecting the motor
connectors with the power
ON is extremely hazardous and may result in serious bodily injury as the
Manipulator may move abnormally, and also may result in electric shock and/or
malfunction of the robot system.
■
To shut off power to the robot
system, disconnect the power plug from the power
source. Be sure to connect the AC power cable to a power receptacle. DO NOT
connect it directly to a factory power source.
■
Before performing any replacement procedure, turn OFF the Controller and
related equipment, and then disconnect the power plug from the power source.
Performing any replacement procedure with the power ON is extremely hazardous
and may result in electric shock and/or malfunction of the robot system.
Name
Quantity
NOTE
Maintenance
part
LED Lamp Unit 1 2182673
Tools
Cross-point screwdriver (No. 2)
1
For cross-recessed screw
Nippers
1
Material
Wire tie
1

Epson T-B Series Specifications

General

Brand	Epson
Model	T-B Series
Category	Robotics
Language	English