Epson T-B Series - Page 73

T3-B T6-B Maintenance 9. Joint #1
T-B series Maintenance Manual Rev.1 61
(16)
Remove the
elliptic cam bearing from the
Joint #1 motor.
There is a brass bushing in one of the set
screw
holes. Be sure not to lose the bushing.
T3-B: A: Brass bushing M4
B: Set screw 2-M4×6
B:Set screw
A: Brass bushing
Elliptic cam bearing
Joint #1
motor
T3-B
T6-B: A: Brass bushing M5
B: Set screw 2-M5×6
B:Set screw
A: Brass bushing
Elliptic cam bearing
Joint #1
motor
T6-B
(17)
T6
-B : Unscrew the motor mounting screws.
Then, remove the Joint #1 flange and
O-ring.
4-M4×12+small washer
There is an O-ring between the Joint #1
flange and the motor.
Be sure not to lose the O-ring.
Joint #1 flange
Joint #1
motor
T6-B
4-M4×12
Small washer

NOTE