92
Environmental Conditions
*: When the specified roll paper type is used ("Paper Specifications" on page 83)
Thermal paper Liner-free label paper*
Temperature/Humidity
Operating
5°C to 45°C {41°F to 113°F}, 10% to 90%
RH, non-condensing (See the operating
environment range below.)
5°C to 35°C {41°F to 95°F}, 20% to 80% RH,
non-condensing (See the operating
environment range below.)
Storage
-10°C to 50°C {14°F to 122°F}, 10% to
90%RH
(paper excluded)
-10°C to 50°C {14°F to 122°F}, 10% to
90%RH
(paper excluded)
Vibration resistance
When
packed:
Frequency: 5 to 55 Hz
Acceleration: Approximately19.6 m/s² {2G}
Sweep: 10 minutes (half cycle)
Duration: 1 hour
Directions: XYZ
There is no external or internal visible damage and the unit operates normally after
being subjected to vibration.
Impact resistance
When
packed:
Package: EPSON standard package
Height: 60 cm {23.62"}
Directions: corner, 3 edges, and 6 surfaces
There is no external or internal visible damage and the unit operates normally after
being dropped.
When
unpacked:
Height: 5 cm
Directions: Lift one edge and release it
There is no external or internal visible damage and the unit operates normally after
being dropped while not operating.
Acoustic noise
Operating
Approximately 52 dB (ANSI Bystander position)
NOTE) The values above are measured in the Epson evaluation condition.
Acoustic noise differs depending on the paper used, printing contents, and the setting
values, such as print speed or print density.
5 34 40 45
90
65
10
Ambient Temperature
Operating environment
[㸣RH]
>Υ@
34°C {93.2°F}, 90㸣
40°C {104°F}, 6
45°C {113°F},
Relative humidity
90
60
10
Ambient Temperature
Operating
environment
[㸣RH]
15°C {59°F}, 80㸣
25°C {77°F}, 60㸣
35°C {95°F}, 45㸣
80
20
45
Relative humidity
5 15 25 35 40 45 >Υ@
To Next Page
Loading...
