119
Appendix
Setting Items for Software Setting Mode
For details about how to set the software setting mode, see "Memory Switch Setting Mode" on page
96.
Setting Item
Setting Values
* Underlined values are the initial settings.
1st page 2nd page 3rd page
1: Print Current Settings -
2: Print Density 1: Monochrome 100%, 105%, 110%, 115%, 120%, 125%,
130%, 70%, 75%, 80%, 85%, 90%, 95%,
Depends On Dip Switch
2: Multi-Tone 100%, 105%, 110%, 115%, 120%, 125%,
130%, 70%, 75%, 80%, 85%, 90%, 95%
3: Baud Rate
*1
2400bps, 4800bps, 9600bps, 19200bps,
38400bps
, 57600bps, 115200bps
4: Automatic
Paper Reduction
1: Upper Margin Enable, Disable
2: Lower Margin Enable, Disable
3: Blank Line Spacing 25%, 50%, 75%, Not Reduce
4: Blank Space 25%, 50%, 75%, Not Reduce
5: Barcode Height 25%, 50%, 75%, Not Reduce
5: Auto Paper Feed&Cut at cover close Enable, Disable
6: Paper Width 80mm, 58mm
To Next Page
Loading...
