Epson TM-T88V-i

6
About this Manual
Aim of the Manual
This manual aims to provide all the information necessary for the development, design, and
installment of POS systems, order entry systems, and other receipt issuing systems that use TM-
T88V-i.
TM-T88V-i provides different available functions depending on the product specification a
nd TM-i
Firmware version.
Refer to an appropriate Technical Reference Guide described in the following table.
*1: You can check the rear of the printer for the availability of serial ports.
*2: Print a status sheet to confirm the version of TM-i Firmware. Make sure that this product is ready
t
o print (the paper is set and the power is turned on), and hold down the push button at the rear of
this product for at least 3 seconds before releasing it.
(See "Confirming with a status sheet" on page 54.)
TM-T88V-i product
specification
*1
TM-i Firmware Version
*2
Technical Reference Guide to be used
TM-T88V-i 
(with a Serial port)
Ver.4.0 or later
TM-T88V-i (TM-i Firmware Ver.4.0 or later) 
Technical Reference Guide
TM-T88V-i 
(without a Serial port)
Ver.4.0 or later
TM-T88V-i (TM-i Firmware Ver.4.0 or later) 
Technical Reference Guide
Ver.3.x or earlier
TM-T88V-i (TM-i Firmware Ver.3.x or earlier)
Technical Reference Guide (This document)
TM-T88V-i (without a Serial port) TM-T88V-i (with a Serial port)
TM-i Firmware Ver.3.x or earlier TM-i Firmware Ver.4.0 or later
“Software” (TM-i Firmware Version) is printed
under <General Information>.
“Firmware” (TM-i Firmware Version) is printed
under <General Information>.
15 pin connector (Female)
(Blue)
9 pin connector (Male)
<General Information>
Software
X.XX
Model
TM-T88V-i
<General Information>
Firmware
X.XX
ePOS-Device
X.XX