50
Functions
Setting the paper width
•80 mm (initial setting)
•58 mm
Setting the print density
Selectable from “Depends On Dip Switch”, or levels 1 to 13 (70% 130%)
Setting the multiple tone print density
Selectable from levels 1 to 13 (70% 130%) (initial setting: level 7)
Setting the print speed
Selectable from levels 1 to 13 (Slow Fast) (initial setting: level 13)
Setting font
•Code page: Selectable from 43 pages
•International character set: Selectable from 18 sets
•Font A/B replacement
Be sure to install the roll paper guide when you select the 58 mm paper width. (See
"Changing the Paper Width" on page 33.)
Once you change the paper width from 80 mm to 58 mm, you cannot change it back to 80
mm.
When the print density is set to "Depends On Dip Switch" (Initial Settings), the Dip switch
settings are applied. With other settings, the customized value settings are applied.(See
"Functions" on page 31.)
First change the print density, and then configure the multiple tone print density.
If you set the density too high, the contrast becomes lower. Select the density level checking
the overall tone balance of your image.
Depending on print conditions, such as print duty and print head temperature, print speed is
automatically adjusted, which may cause white lines due to intermittent print (the motor
sometimes stops). To avoid this, keep the print speed constant by setting it lower.
To Next Page
Loading...
