EasyManua.ls Logo

Epson TM-T88V-i

Epson TM-T88V-i
166 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
32
DIP Switch Bank 2
SW Function Function ON OFF
Initial
setting
2-1
Reserved
(Do not change setting)
Fixed to ON ON
2-2
Reserved
(Do not change setting)
Fixed to OFF OFF
2-3
Selects print
density
Standard 2-3: OFF, 2-4: OFF
OFF
Darker than
standard
2-3: ON, 2-4: OFF
2-4
Dark 2-3: OFF, 2-4: ON
OFF
Forbidden 2-3: ON, 2-4: ON
2-5
Sets the release condition of the
receive buffer BUSY state.
(This function is effective when
DIP Switch 1-2 is set to off.)
Releases the BUSY
state when the
remaining capacity
of the receive buffer
reaches 138 bytes.
Releases the BUSY
state when the
remaining capacity
of the receive buffer
reaches 256 bytes.
OFF
2-6
2-7
Reserved
(Do not change settings)
Fixed to OFF OFF
2-8
IF pin 31 reset signal
(Do not change setting)
Fixed to ON ON
Do not change the setting of DIP switches 2-1, 2-2, 2-6, 2-7, and 2-8. Otherwise, the product
may not operate normally.
Set the print density using the DIP switches when the print density of the customized value is
set to "Depends On Dip Switch" (Initial Settings).
If the print density is set to “Darker than standard” or “Dark” level, printing speed may be
reduced.

Table of Contents

Other manuals for Epson TM-T88V-i

Related product manuals