ero electronic DPS - Alarm 2; Filter on the Alarm Threshold; Safety Lock; End

38
12) ALARM 2
Same as alarm 1
13) FILTER ON THE ALARM THRESHOLD
The display will show "FILt" followed by a number.
Using ▲ and ▼ pushbuttons it is possible to select the same time
constant selected for readout or the exclusion of the filter (0
setting).
Push the F pushbutton to memorize the new choice and go to the
next parameter.
14) SAFETY LOCK
The display will show "KY" preceded by:
0 = no threshold protection. The alarm threshold
may be modified in every moment during
operating mode.
1 = Ever active protection. Alarm threshold couldn't
be modified.
2 - 9999= This value is a secret value and it could be
necessary to put the instrument in unlock
condition and modify alarm threshold during
operative mode.
NOTE: When safety lock is selected, the secret value cannot be
displayed again.
It is important to record the secret value accurately.
If the secret value is lost, a new value should be set.
15) END
At the end of configuration procedure the display will show "COnF"
and it is possible to review the parameter setting or go to the
operating mode.