ero electronic DPS - 6.4 Default Calibration Parameters; 6.5 Default Operative Parameters

55
9.a Retransmission minimum scale value -1999
9.b Retransmission maximum scale value 9999
9.c Digital filter on the analog retran. None
10 Serial interface address 00
10.a Baud rate 19200
10.b Byte format 7bit + even parity
11 Alarm 1 type High alarm with
automatic reset
11.a Alarm 1 hysteresis 0.1 %
12 Alarm 2 type low alarm with
automatic reset
12.a Alarm 2 hysteresis 0.1 %
13 Digital filter on the alarm threshold None
14 Safety lock 0
6.4 DEFAULT CALIBRATION PARAMETERS
The default calibration parameters allow to verify the correct working
of the instrument but they are not calibration parameters.
NOTE: After default calibration parameters loading, it is necessary to
recalibrate the instrument.
6.5 DEFAULT OPERATIVE PARAMETERS
Alarm 1 threshold initial scale readout
Alarm 2 threshold initial scale readout