Escea DF960 - Fitting the Fascia and Finishing Installation; F1 Fitting the Fascia; F2 Locating Wall Mount Cradle for Remote

B
A
C D E F G SERVICE
44
F
Fitting the Fascia and Finishing Installation
F1 Fitting the Fascia
Slide the top of the fascia (the side with two prongs facing away from the front face) into the fascia
rails attached to the chassis in the two top corners. Push the bottom fascia lip above the chassis base.
The fascia should now be flush with the wall.
F2 Locating Wall Mount Cradle for Remote
The appliance’s remote contains the thermostat that will sense the room temperature and
communicate this back to the heater via radio frequency.
A wall mount cradle has been provided for the wireless control and where possible the control should
be housed in this cradle.
The location of this cradle should be decided by taking into account the following factors:
□ Simple and convenient access for the user
□ Away from air flow and drafts through the room
□ The parts of the room that people are likely to spend time
□ Away from direct sun light
□ A suitable distance away from the heater
□ Ideally 1.2m to 1.5m from the floor
The radio frequency signal will go through some walls but for best
results Escea suggest that the cradle position is less than 10 metres
away from the heater.
The best height o the ground to locate the cradle is about chest
height. This gives a good average room temperature and easy access for the user.