B
A
C D E F G SERVICE
54
S2 Serial Number
The serial number for the fire can be found in two places. The first is in the battery compartment of
the remote under the batteries. The second is on the data sticker on the chassis under the firebox on
the left hand side.
S3 Checking Operating Pressure
See section E9 on page 37 of this manual.
S4 Cleaning the Fascia
The outside of an Escea Fascia must only be cleaned with a soft microfibre cloth. If heavier cleaning is
required for the likes of grease or stubborn fingerprint removal we recommend the use of a dedicated
stainless steel cleaner for stainless steel fascias or warm soapy water for powder coated fascias. These
wipes have been tested by Escea technicians and produce very satisfying results, when used correctly.
Instructions for their use follow.
NEVER RUB THE FASCIA.
For Stainless Steel Fascias:
1. Ensure that the Gas Fireplace is o and that the fascia is cold to the touch.
2. Using the gloves provided with your fascia, a stainless steel cleaner and a clean cloth, apply a small
amount of cleaner to the cloth and wipe the fascia with even, straight strokes.
3. Make sure your strokes follow the direction of the grain or brush finish. Wiping across the grain can
leave small scratches.
4. The wipe will leave a very fine film over the fascia, ensure this film is distributed evenly.
5. If the film is applied too heavily and is quite visible, you can remove the excess by gently wiping dry
with a microfibre cloth. Ensure your strokes still follow the direction of the grain or brush finish.
6. Ensure that no film is applied to the glass of your Escea Gas Fireplace. If applied accidentally, wipe
o with an absorbent microfibre cloth.
For Powder Coated Fascias:
1. Ensure that the Gas Fireplace is o and that the fascia is cold to the touch.
2. Using the gloves provided with your fascia, gently clean the fascia with a cloth and warm soapy
water.
3. Wipe o with an absorbent microfibre cloth.
Cleaning the Log Set and Glass
This is a service procedure that will need to be carried out whenever soot builds up on logs and/or
inside of glass. If soot build up becomes excessive or regular then one of the following actions may be
required:
• Check gas pressure; operating gas pressure may be too high.
• Reposition log set so that each log is sitting correctly in the log retainer bracket.
• Clear any blockage from primary air port of burner.
• Check flue tube is not damaged or disconnected.
For diagrams and further info on removing your fascia, reverse the steps found in section F on page 44.
• Refer to section D2 on page 31 for instructions on removing the glass. Note that the
fiberglass tape around the glass can cause marking on carpet or furnishing.
• Clean the inside and outside of both pieces of glass with normal ammonia-free glass
cleaning products. Use a CLEAN DRY cloth only. Stubborn marks may be cleaned with a
ceramic glass cleaner.
• Replace in opposite order and test run heater.
To Next Page
Loading...
