Escea DF960 - F3 Operating the Appliance for the First Time; F4 Normal Operating Sounds and Smells

B
ACDEFGSERVICE
45
Please ensure that the cradle is screwed firmly onto the wall using the screws provided.
F3 Operating the Appliance for the First Time
Remove the battery cover on the rear of the remote. Insert the new “AA” size batteries, paying
attention to the polarity.
You should now see on the display of the remote the time showing “0:00”.
To turn the fire on, press the “POWER” button once, and within a few seconds the appliance will begin
its startup sequence.
NOTE: once the rear burner has lit there will be a fixed 15 second delay before the front burner will light.
When the appliance has lit, set the room temperature by pressing the ‘plus’ or ‘minus’ button
repeatedly until the display is showing the desired temperature. The remote will then revert back to the
‘current’ room temperature 30 seconds after making the change.
Run the appliance on full for an hour with the windows and doors open in the dwelling. This will ensure
any running-in smells have the chance to dissipate.
The appliance is turned o by pressing the “POWER” button once more. The remote will display the
time only.
Run the appliance again and check the operation of the thermostat by increasing and reducing the set
temperature. Check the Flame Eect function and the Fan Boost functions work correctly.
For further operation instructions please refer to the User Guide.
F4 Normal Operating Sounds and Smells
Note: Each time the fire is lit from cold the glass may fog up with condensation. This is normal and the
condensation will disappear within a few minutes once the glass heats up.
Sounds
It is possible that you will hear some sounds from your gas appliance. This is perfectly normal due to
the fact that various types of materials are used within your appliance. Listed below are some examples.
These are all normal operating sounds and should not be considered as defects in your appliance.
Fan:
Escea gas appliances use electric fans to push heated air into the room. It is not unusual for the fan to
make a “whirring” sound when ON. This sound will increase or decrease in volume depending on the
speed setting of your fan.
Gas Control Valve:
As the gas control valves turn ON and OFF, a dull clicking sound may be audible. This is the normal
operation of a valve. When the fire is switched o after being run for a while, there may be popping
and fluttering noises as the residual gas in the burners burns away. These are normal and are no cause
for concern.