S
66
630791 DS MKII INSTALLATION MANUAL
5. Move to the back of the re for the following steps. Remove the screws (circled in the diagram below) from in the
chassis back panel of the appliance. Remove the chassis back panel.
6. Undo the 1/4 turn fasteners (circled below) and allow the rebox back panel to lean forward so you may li the
panel out.
7. Relocate the diagnosc bracket to the opposite side of the appliance by carefully removing the middle screw and
feeding it through to the opposite side of the re (as shown in the diagram below).
8. Remove the boom trim (shown below) by pulling to release it from the appliance, taking care not to scratch the
side trims.
To Next Page
Loading...
