IP Server 900 Programming Manual Function 6: Recording of prompts
I.6
2. Select to enable call recording
The call recording service for this line is authorized as displayed. Press a scroll key to change — or,
to confirm the current setting, press #.
Default: NO.
CO LINE
RECORDING: NO >
Function 6412: T1 line recording settings
1. Choose T1 lines to program
You can select from the first set of 12 CO lines on the first T1/PRI Module. Use the scroll keys to
view the next 12 CO lines on the same T1/PRI Module. To see the first 12 CO lines on the second
T1/PRI Module (if installed), scroll again; if there is only one T1/PRI Module installed, scrolling will
return you to the first 12 CO lines.
Note: A 48-Key Feature Phone will display the first set of 24 CO lines on the T1/PRI Module;
scrolling again will allow you to select the 24 CO lines on a second T1/PRI Module.
Select the CO lines to be programmed alike and press # to confirm. The LEDs on the keys for the
selected lines will glow green; then, after a CO line is programmed, its key’s LED will glow amber.
Programming of the first CO line should default forward for the remaining CO lines selected. After
the selected CO lines are programmed, their keys’ LEDs will glow amber.
If a T1/PRI Module in installed on the second carrier card, the display will be:
CC 2 T1 DAY
32-55 >
2. Select to enable call recording
The call recording service for this line is authorized as displayed. Press a scroll key to change — or,
to confirm the current setting, press #.
Default: NO.
CO LINE
RECORDING: NO >
To Next Page
Loading...
