IP Server 900 Programming Manual Function 8: IP programming
L.14
4. Enter (or view) the public IP address to use when NAT is enabled. Press # to continue.
Range: 0.0.0.0 through 255.255.255.255. Default: 0.0.0.0.
CC 4 PUBLIC IP
0.0.0.0
5. Enter the IP address for the primary DNS
1
server. Press # to continue.
Range: 0.0.0.0 through 255.255.255.255. Default: 0.0.0.0.
CC 4 PRI DNS IP
0.0.0.0
6. Enter the IP address for the secondary DNS server. Press # to continue.
Range: 0.0.0.0 through 255.255.255.255. Default: 0.0.0.0.
CC 4 SEC DNS IP
0.0.0.0
7. Enter the UDP port SIP phones will connect to. Press # to continue.
Range: 1-65535. Default: 5070.
SIP STATION PORT
5070
8. Either press 1 to save your SIP trunking changes or press 2 to exit without restarting SIP trunking.
RESTART IP/ASC 4
1=YES 2=EXIT
Note: Changes made to SIP trunking programming require that the IP/ASC Carrier Card be restarted in
order for the changes to be uploaded to the IP/ASC Carrier Card. Press 1 to restart the SIP ITSP now
or press 2 to exit and return to the main menu.
Warning: Restarting the SIP ITSP will cause any calls in progress to be disconnected.
Function 86: Unified Messaging selection
Use the scroll keys to select the IP/ASC Carrier Card to use for Mobile Messaging. Press # to continue.
Choices: IP/ASC Carrier Card 1, 4, 7, and 10, depending on what (if any) additional IP/ASC Carrier Cards
are installed on the system. Default: None.
ASC MOBILE MSG
NONE >
1
Domain Name System.
To Next Page
Loading...
