IP Server 900 Programming Manual System programming: An introduction
C.5
Entering programming mode
You may program from any ESI desktop phone in the system:
1. Press PROG/HELP at any station. The normal station programming menu prompts will begin to play.
2. Press HOLD. The “enter password” prompt will play.
3. Enter the Installer password (default is 7 8 9).
1
Then, to confirm the password, either press # or wait two
seconds. You are now in programming mode. The extension will be automatically placed in DND, and
its display will show:
INSTALLER
CMD:
4. The system will play the system programming menu. Follow it to program as you wish.
5. When finished, hang up.
Warning: Always FINISH programming in ANY function BEFORE exiting programming mode (as needed, press # to
accept current entries for function parameters you’re not changing).
Note: The system will automatically exit programming mode after 10 minutes of inactivity.
Example: If your Installer password is 864, enter programming mode by pressing PROG/HELP HOLD 8 6 4 #.
(To exit programming mode, hang up.)
1
If you prefer to enter Administrator programming mode, use the Administrator password, instead (the default is 4 5 6).
To Next Page
Loading...
