IP Server 900 Programming Manual Function 8: IP programming
L.9
The following parameters will be displayed only if unified messaging has been installed on the system:
5. NSP remote messaging e-mail server — Enter the IP address of the customer’s e-mail server.
Press # to confirm.
Range: 1.0.0.1 through 254.254.254.254.
VM EMAIL SERVER
0.0.0.0
6. Outgoing SMTP mail server — Enter the name of the outgoing e-mail SMTP server (for example,
smtp.myisp.com). To enter a period (“dot”), press 0. Press # to confirm.
OUT SMTP NAME
NOT PROGRAMMED
7. Outgoing SMTP mail server port number — Enter the port number for the outgoing SMTP mail
server. Press # to confirm.
Range: 1–65535. Default: 25.
OUT SMTP PORT
NUMBER: 25
8. VIP 7 remote messaging e-mail address — Enter the e-mail address assigned by the e-mail System
Administrator. To enter a period (“dot”), press 0. To enter the @ (“at”) symbol, press # #.
Press # to confirm.
VM EMAIL ADDR
NOT PROGRAMMED
9. VIP 7 remote messaging e-mail address password — Enter the password for the unified messaging
e-mail address, as assigned by the e-mail System Administrator. Press # to confirm.
EMAIL PASSWORD
NOT PROGRAMMED
10. Primary e-mail domain name server — Enter the IP address of the domain name server (DNS) used
by the NSP remote messaging e-mail server (see step 5). Press # to confirm.
Range: 1.0.0.1 through 254.254.254.254.
PRI EMAIL DNS IP
0.0.0.0
To Next Page
Loading...
