Espressif ESP32-S2 User Manual

Chapter 2. API Reference
CONFIG_OPENTHREAD_DIAG
Enable diag
Found in: Component config > OpenThread > CONFIG_OPENTHREAD_ENABLED
Select this option to enable Diag in OpenThread. This will enable diag mode and a series of diag com-
mands in the OpenThread command line. These commands allow users to manipulate low-level features
of the storage and 15.4 radio.
Default value:
• Yes (enabled) if CONFIG_OPENTHREAD_ENABLED
CONFIG_OPENTHREAD_COMMISSIONER
Enable Commissioner
Found in: Component config > OpenThread > CONFIG_OPENTHREAD_ENABLED
Select this option to enable commissioner in OpenThread. This will enable the device to act as a com-
missioner in the Thread network. A commissioner checks the pre-shared key from a joining device
with the Thread commissioning protocol and shares the network parameter with the joining device upon
success.
Default value:
• No (disabled) if CONFIG_OPENTHREAD_ENABLED
CONFIG_OPENTHREAD_JOINER
Enable Joiner
Found in: Component config > OpenThread > CONFIG_OPENTHREAD_ENABLED
Select this option to enable Joiner in OpenThread. This allows a device to join the Thread network with
a pre-shared key using the Thread commissioning protocol.
Default value:
• No (disabled) if CONFIG_OPENTHREAD_ENABLED
CONFIG_OPENTHREAD_SRP_CLIENT
Enable SRP Client
Found in: Component config > OpenThread > CONFIG_OPENTHREAD_ENABLED
Select this option to enable SRP Client in OpenThread. This allows a device to register SRP services to
SRP Server.
Default value:
• No (disabled) if CONFIG_OPENTHREAD_ENABLED
CONFIG_OPENTHREAD_BORDER_ROUTER
Enable Border Router
Found in: Component config > OpenThread > CONFIG_OPENTHREAD_ENABLED
Select this option to enable border router features in OpenThread.
Default value:
• No (disabled) if CONFIG_OPENTHREAD_ENABLED
Espressif Systems 1214
Submit Document Feedback
Release v4.4

Espressif ESP32-S2 Specifications

General

Brand	Espressif
Model	ESP32-S2
Category	Single board computers
Language	English