EasyManua.ls Logo

Espressif ESP32-S2 - Page 136

Espressif ESP32-S2
1695 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 2. API Reference
WIFI_EVENT_STA_WPS_ER_FAILED
ESP32 station wps fails in enrollee mode
WIFI_EVENT_STA_WPS_ER_TIMEOUT
ESP32 station wps timeout in enrollee mode
WIFI_EVENT_STA_WPS_ER_PIN
ESP32 station wps pin code in enrollee mode
WIFI_EVENT_STA_WPS_ER_PBC_OVERLAP
ESP32 station wps overlap in enrollee mode
WIFI_EVENT_AP_START
ESP32 soft-AP start
WIFI_EVENT_AP_STOP
ESP32 soft-AP stop
WIFI_EVENT_AP_STACONNECTED
a station connected to ESP32 soft-AP
WIFI_EVENT_AP_STADISCONNECTED
a station disconnected from ESP32 soft-AP
WIFI_EVENT_AP_PROBEREQRECVED
Receive probe request packet in soft-AP interface
WIFI_EVENT_FTM_REPORT
Receive report of FTM procedure
WIFI_EVENT_STA_BSS_RSSI_LOW
APs RSSI crossed configured threshold
WIFI_EVENT_ACTION_TX_STATUS
Status indication of Action Tx operation
WIFI_EVENT_ROC_DONE
Remain-on-Channel operation complete
WIFI_EVENT_STA_BEACON_TIMEOUT
ESP32 station beacon timeout
WIFI_EVENT_MAX
Invalid WiFi event ID
enum wifi_event_sta_wps_fail_reason_t
Argument structure for WIFI_EVENT_STA_WPS_ER_FAILED event
Values:
WPS_FAIL_REASON_NORMAL = 0
ESP32 WPS normal fail reason
WPS_FAIL_REASON_RECV_M2D
ESP32 WPS receive M2D frame
WPS_FAIL_REASON_MAX
enum wifi_ftm_status_t
FTM operation status types.
Values:
FTM_STATUS_SUCCESS = 0
FTM exchange is successful
FTM_STATUS_UNSUPPORTED
Peer does not support FTM
Espressif Systems 125
Submit Document Feedback
Release v4.4

Table of Contents