ES415.1 - User’s Guide12
Basic Safety Notices ETAS
Requirements for the place of installation
• Place the module or the module block on a smooth, even and firm foun-
dation.
• The module or module block must always be securely fastened.
Requirements on the ventilation
• Keep the module away from heat sources and protect it against direct
exposure to the sun.
• The free space above and behind the module must be selected so that
sufficient air circulation is ensured.
Fixing the module on a carrier system
When selecting the carrier system, observe the static and dynamic forces that
could be created by the module or the module block at the carrier system.
Damage of the module and loss of properties acc. to IP67
Transport
• Mount and connect the modules only at the location of their startup!
• Do not transport the modules at the cable of the module or any other
cables.
Damage or destruction of the module is possible.
The modules of series ES400 are approved only for installation and
operation at components or locations that ensure compliance with
the technical data of the modules, such as:
• the resistance to vibration of the modules (for example, install
modules only on spring-loaded bodies, not on wheel suspensions
or directly at the motor) and
• the temperature resistance of the modules (for example, do not
install modules on the motor, turbocharger, exhaust manifold or
their environments).
During the installation of the modules, observe the permissible tem-
perature range of the cable ties being used!
Loss of Features as defined by IP67!
Water standing at the pressure balance element damages the mem-
brane!
Please observe which way the module is pointing when installing ver-
tically!
To Next Page
